Removing bearing shields

[Ed Alt]

These are the stainless stell shield type.
  ----- Original Message ----- 
  From: Nat Penton 
  To: discussion at nsrca.org 
  Sent: Saturday, September 25, 2004 12:53 PM
  Subject: Re: Removing bearing shields


  Ed you will get longer service life if you do not remove the shields. I'm assumming this is the same bearing, rubber seals, that I am using on the 91FX. You need to provide adequate crankcase coling.            Nat Penton
    ----- Original Message ----- 
    From: rickwallace45 
    To: discussion at nsrca.org 
    Cc: Ed Alt 
    Sent: Saturday, September 25, 2004 6:24 AM
    Subject: RE: Removing bearing shields


    Take a small punch (or your smallest jeweler's screwdriver.)  and pop a tiny hole in the shield (between balls of course). The metal shield will start to deform  from that - then lever the shield out of the bearing either using the hole or an edge exposed from the hole- making. 



    No damage to the bearing this way. 



    -----Original Message-----
    From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org] On Behalf Of Ed Alt
    Sent: Saturday, September 25, 2004 3:02 AM
    To: discussion at nsrca.org
    Subject: Removing bearing shields



    I have a set of stainless steel shielded bearings for my OS 1.60 and need to remove the shields.  I haven't figured out a way to do it yet without damaging the bearing.  Any ideas?  Special tools?  Help!



    Thanks

    Ed
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040925/a39e5d00/attachment.html