doublers

[Wayne Galligan]

Good one Jim... I forgot to mention leaving out the rudder post.   I have
good success using med.c/a on just about everything except the firewall and
l.g box where a slow set glue works the best.   Either would work just fine.

WG

----- Original Message ----- 
From: "Jim Ivey" <jivey61 at bellsouth.net>
To: <discussion at nsrca.org>
Sent: Friday, November 26, 2004 8:38 AM
Subject: Re: doublers


>
> > Tom
> If you have a fiberglass or molded fuse,leave out the rudder post 'till
the last step, then you can reach the doublers area.Also make sure the glue
area is clean of release agent from the F/G process. Epoxy usually is best
to use here.
>
> Jim Ivey
> > From: "Tom Hinton" <tph1 at bellsouth.net>
> > Date: 2004/11/26 Fri AM 09:10:13 EST
> > To: <discussion at nsrca.org>
> > Subject: doublers
> >
> > What is the best way to add balsa doublers to the inside of the fuse for
hor. stab?
> > thanks
> >
>
> =================================================
> To access the email archives for this list, go to
> http://lists.f3a.us/pipermail/nsrca-discussion/
> To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=================================================
To access the email archives for this list, go to
http://lists.f3a.us/pipermail/nsrca-discussion/
To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.