TT Pro 1.20 Question

[Mike Hester]

Yes, open vent line, straight out to the outside. Run the other through a
fuel tee and into the pump, with a dot on the other part of the tee. Then
one line from the pump to the carb.

Seems like I was running a 14x13 or 15x12 on that engine, with a CD
cannister exhaust and it would pull like crazy. A lot like an OS 140 in a
lot of ways, but wouldn't idle down quite as well. Great engine though.

-Mike

----- Original Message ----- 
From: "Paul Lawrence" <pwl45 at yahoo.com>
To: <discussion at nsrca.org>
Sent: Tuesday, June 29, 2004 6:46 PM
Subject: TT Pro 1.20 Question


> I'm experimenting with a Thunder Tiger Pro 1.20 and wondered if anyone
knew
> how the tank should be vented. The manual says to run the fuel pickup line
> to the inlet on the pump and connect the pump outlet to the carb. Then it
> says, "Never to connect the tube from muffler/pipes pressure nipple to
fuel
> tank with this pump system." I'm thinking I just need to run an open vent
> line. Does that sound right?
>
> Also, any advice on what prop to run?
> This engine will be in a Tai Ji .60, runnning Pro Pattern 20%, weighting 9
> lbs and running the TTR 9712 pipe.
>
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>


=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.