Engine carbon

[Ed Hartley]

Hi Anthony,

I used Mobile one after run for a short time. It gummed up my engine so bad,
I had to take it apart and totally clean it. I just run the fuel out now and
have around 160 flights on it, (with the original bearings!). It is also an
OS RX.

You might want to take a look at:
http://www.rcpattern.com/2cycle.htm
There is a lot of information from a lot of folks there about two strokes in
general.

Best,
Ed

----- Original Message ----- 
From: "Anthony Romano" <anthonyr105 at hotmail.com>
To: <discussion at nsrca.org>
Sent: Wednesday, June 16, 2004 10:27 AM
Subject: Engine carbon


>
> While doing a bearing swap in my high maintenaince, high nitro, hight
parts
> count OS Rx, I noticed a lot of carbon on the piston top. Since this is
such
> a common procedure I was surprised that I had not noticed this before. Is
> this common? Is this due to the two percent castor in my fuel or the Mobil
> one after run?
>
> Any constructive comments would be appreciated.
>
> Tongue firmly in cheek
>
> Anthony
>
> Happy owner of YS 1.20 NC 2 YS 1.40 L  and 2 OS 1.40 Rx
>
> _________________________________________________________________
> MSN 9 Dial-up Internet Access fights spam and pop-ups – now 3 months FREE!
> http://join.msn.click-url.com/go/onm00200361ave/direct/01/
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>
>

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.