OS 1.60 Issues

[Tom Hinton]

Very good idea Wayne.
----- Original Message -----
From: "Wayne Galligan" <wgalligan at goodsonacura.com>
To: <discussion at nsrca.org>
Sent: Wednesday, June 02, 2004 6:47 PM
Subject: Re: OS 1.60 Issues


> I ran the ST2300 with a hopper tank in a Prophecy.  The thing about this
> setup is to get the tank in line with the carb if your using muffler
> pressure only.  In my Prophecy the tank set high at the top of the fuse.
> Almost 3" higher then the carb. On outside pushes the engine would go lean
> because the tank then was way below the carb.  A Perry pump cured the
> problem and there is no need to pressurize the tank.   I still run a
hopper
> tank on my current setups even with the pumped engines to eliminated air
in
> the line when the tank gets low.  The hopper helps eliminate air bubbles
and
> its easy to insulate the hopper tank from vibration.
>
> Wayne G.
>
>
>
> ----- Original Message -----
> From: "Linda Carnes" <flyinglady at mypccrashed.com>
> To: <discussion at nsrca.org>
> Sent: Wednesday, June 02, 2004 4:12 PM
> Subject: RE: OS 1.60 Issues
>
>
> > The Perry pump works very well for putting the tank on the CG.
> >  Other wise the fuel line on the hopper would go to the carb and the
vent
> to
> > the fuel line on the main tank. Just set up fueling so it fills the
hopper
> > then the main.
> >
> > Sincerely
> >
> > Linda Carnes
> >
> >
> > Combined PC Support Services Inc.
> > Phone: (706) 253-7677
> > Toll Free: (866) 286-2379
> > Fax: (706) 253-7679
> > Cell Phone:(770) 401-7634
> > E-Mail: lac at mypccrashed.com
> > Corp. Web Page: www.mypccrashed.com
> >
> >
> >
> > =====================================
> > # To be removed from this list, go to
http://www.nsrca.org/discussionA.htm
> > and follow the instructions.
> >
> >
>
>
> =====================================
> # To be removed from this list, go to http://www.nsrca.org/discussionA.htm
> and follow the instructions.
>

=====================================
# To be removed from this list, go to http://www.nsrca.org/discussionA.htm
and follow the instructions.