Perry pump question

[Tom Hinton]

RE: Perry pump questionThanks everyone.
  ----- Original Message ----- 
  From: Mark Hunt 
  To: discussion at nsrca.org 
  Sent: Saturday, July 17, 2004 9:53 PM
  Subject: Re: Perry pump question


  I did this also, but just for good measure, I used a small piece of brass tubing as a drill guide to protect the threads as I drilled through the tapped hole into the crackcase.  I also held the motor above the drill to allow most of the chips to fall out toward the drill and not into the motor.



    ----- Original Message ----- 
    From: Chuck Czarnik 
    To: discussion at nsrca.org 
    Sent: Saturday, July 17, 2004 3:32 PM
    Subject: RE: Perry pump question


     Yes.  You can drill the top left hole deeper in the 1.60 of the backplate with a drill bit smaller than the threads.  Go buy OSMG7909, which is the pressure fitting from the 1.60 FI engine.  Of course clean filings out of engine yada yada...

    Did this with my 1.60 a couple of years ago... Very clean way for pressure fitting, no worries about # of threads.  HTH, Chuck

    -----Original Message-----
    From: discussion-request at nsrca.org
    To: discussion at nsrca.org
    Sent: 7/17/04 11:53 AM
    Subject: Perry pump question

    Does anyone know if the same nipple used on the OS 160 can be used on
    the OS 91 fx in the same manner ie. the top left hole on the backplate?
    thanks, Tom


-----------------------------
NOTICE:  The information contained in this electronic mail message

is either attorney privileged and/or confidential information intended
only for the use of the individual or agent responsible to deliver
it to the intended recipient; or, alternately, proprietary information
(trade secret).  You are hereby notified that any dissemination,

distribution or copying of this communication or unauthorized use of the

information herein contained, is strictly prohibited. If you have

received this communication in error, please immediately delete it

from your computer and notify the sender of your receipt of this message. 

 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040718/fbe1bfb8/attachment.html