plumbing for Perry Pump setup

[richard.lewis]

Yea, that setup will work fine...

Richard
  -----Original Message-----
  From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]On
Behalf Of randy10926 at comcast.net
  Sent: Monday, December 27, 2004 9:01 AM
  To: discussion at nsrca.org
  Subject: RE: plumbing for Perry Pump setup


  I have been using a two line system and my colwing is already setup for a
two line.  The vent line is the overflow and runs to an L in the cowling.
The main line with the clunk runs to a fuel filter and then the pump on the
webra.  I have a break in the line between the clunk and the pump.  This
break consists of two Ls and a piece of fuel tubing.  I have been breaking
the line to fuel/de-fuel the plane.  That way the pump and carb on the Webra
was not getting flooded during fuelings.

  Would this still work for the perry V30?  Just run the line from the fuel
filter to the perry pump and then from the perry pump to the needle valve?

  Randy

    -------------- Original message --------------

    Randy,

    Yes, D&T the backplate to supply power to the pump.  If using an OS160,
there is a neat fitting available from OS that replaces one of the backplate
screws and provides a pressure tap.  It requires drilling into the bottom of
one of the backplate screw holes, but is a really slick installation.

    I use a three line setup.  One line with a clunk that goes to the pump.
Second line with no clunk pointed into the bottom rear of the tank for
fueling.  Third line for the vent/overflow.   You cannot fuel/de-fuel
through the pump, and if you put a T behind the pump, you will force fuel
through the pump while fueling.  So, the three line makes the most sense so
that you don't have to disconnect a fuel line for fueling.

    The vent/overflow simply gets routed to the exterior of the plane.  The
VP30 does not use a pressurized tank.

    Richard
      -----Original Message-----
      From: discussion-request at nsrca.org
[mailto:discussion-request at nsrca.org]On Behalf Of randy10926 at comcast.net
      Sent: Monday, December 27, 2004 8:23 AM
      To: nvrc club list; discussion at nsrca.org @nsrca.
      Subject: plumbing for Perry Pump setup


      As my excelleron is ready for test flying,  I am making preparations
for re-engining the Focus 2.  I am trying to thinking through the setup and
plumbing for the use of a peryy pump, specifically the V30.

      First need to tap the backplate for crank pressure, then ?

      Would a two line system work?  What about the overflow?

      Would a three line be better?  How would you set it up?

      Randy
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20041227/51f0c4ad/attachment.html