OS91FX

[Nat Penton]

More. A header to your specs can be acquired from kgamueller at rogers.com. . For adequate isolation the Hyde 91 Type A mount is not adequate, ask for the 120 TypeAR (two layers rubber) and ask for 91 beam spacing. Use a nose ring. Dont go under 3" backplate diameter.
  ----- Original Message ----- 
  From: Nat Penton 
  To: discussion at nsrca.org 
  Sent: Tuesday, April 20, 2004 1:11 PM
  Subject: OS91FX


  Scott Boca will tell you which bearing # ( sealed rear only ).The only pump I have run is the Hanno, which is the same as the 140RX. The 140 pump assembly is expensive and you still have to install it with JBWeld. I feel sure the new heli assy with the Perry will be a better choice.The stock carb will work fine but you will need to screw in the idle adjust. I'm running an ES pipe, also a Macks 15cc. I run 2 head shims with the 30% fuel.       nat
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20040420/5007bf15/attachment.html