Quick building question

Tue May 6 19:31:56 AKDT 2003

Not good to use rubbing alcohol.....It contains a bit of water.....best thing is to get 
an epoxy with lower viscosity.

Amir

  ----- Original Message ----- 
  From: Steve Barlow 
  To: discussion at nsrca.org 
  Sent: Tuesday, May 06, 2003 8:10 PM
  Subject: Quick building question

  Guys,

  I'm doing the fiberglass reinforcement over the balsa sheeting where the main wings are joined on a .60 size kit.  Can I use rubbing alcohol to cut the epoxy with to thin it just a bit?  Do you think that would cause me any problems?  It sure would make it easier.

  Thanks,
  Steve
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030506/7aaf32ec/attachment.html