Quick building question

[jim ivey]

Alcohol will thin epoxy. I also use CA and use a piece of plastic wrap from
the kitchen on my fingers, but you need to run a fan on the work area
because bad fumes are given off when that much CA is used in one area.
Jim I

----- Original Message -----
From: "John Crozier" <sjcrozier at comcast.net>
To: <discussion at nsrca.org>
Sent: Wednesday, May 07, 2003 12:18 AM
Subject: Re: Quick building question


> I use thin Ca and squeegee it with an old credit card...croz
> ----- Original Message -----
> From: "Steve Barlow" <stevebarlow at attbi.com>
> To: <discussion at nsrca.org>
> Sent: Tuesday, May 06, 2003 9:10 PM
> Subject: Quick building question
>
>
> Guys,
>
> I'm doing the fiberglass reinforcement over the balsa sheeting where the
> main wings are joined on a .60 size kit.  Can I use rubbing alcohol to cut
> the epoxy with to thin it just a bit?  Do you think that would cause me
any
> problems?  It sure would make it easier.
>
> Thanks,
> Steve
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#