PPG Concept safety

[STEVE HOSNER]

John,
You should be fine. I use basically the same setup and have never had problems in the past. Make sure that you use the proper thinner and catalyst to match up with your temps. The HVLP gun will really help with overspray.

Steve
  ----- Original Message ----- 
  From: John Gausby 
  To: discussion, nsrca 
  Sent: Thursday, July 24, 2003 11:47 AM
  Subject: PPG Concept safety



  Hi folks........I'm ready to spray a 2M fuse using PPG Concept Acrylic Urathane from Radio South. This stuff is new to me after using K&B Superpoxy for many many years.

  I've done some reading on safety including several articles submitted by David Flynt in the K-Factor. David recommends that all body skin be completely covered up and i should wear neoprene gloves. Is a full body suit necessary?

  My paint booth is a seperate 10 X 10 room attached to my shop with a door. I have a large fan in the window that sucks out any fumes very well . The respirator i use is a new 3M double charcoal. I use an HVLP detail gun and a paasche airbrush for spraying..

  Any saftey recommendations from ya'll would be appreciated. I understand this paint can be (especially the chemicals in the hardiner) real nasty..........Thanks.........John Gausby


  John Gausby
  humptybumpty at earthlink.net
  Why Wait? Move to EarthLink.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030724/2cba7bd8/attachment.html