HVLP spray guns

[David Harmon]

I use a Paasche AUTF model with a large siphon jar. This gun has the
capability of shooting a small fan and much larger fans by exchanging
the cap and nozzle.
I have used it with K&B epoxy and dope and Concept and it really works
well as it should as it is a professional grade gun. 
I installed a regulator with air gauge and water trap right on the inlet
of the gun so I can adjust the pressure if needed while spraying. The
compressor regulator is set to it's maximum.
I usually set the pressure at the gun to 20>30 psi when using Concept.
Thin the Concept more than the instructions say for best results.
 
http://www.airbrushes.co.uk/small_sprayguns.htm
 
This link will show you what it looks like. 
 
Regards

Dave Harmon
NSRCA 586
K6XYZ at comcast.net
Torrance, Ca. 
-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Steve & Cindy Kessler
Sent: Tuesday, August 12, 2003 6:31 PM
To: discussion at nsrca.org
Subject: HVLP spray guns
 
I am looking for a moderatly priced HVLP spray gun to paint PPG Concept
on my pattern fuse.  I have looked at the Sata mini gun, but at +$200,
it is more than I want to spend.  Is there a cheaper gun that can give
good paint finishes?
 
Thanks - Steve
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20030814/46e1b315/attachment.html