SERVO GEARS

[wgalligan]

They are getting fairly sloppy making lots of noise when engine is running.   Run them to 3/4 deflection and noise goes away they are that loose.
Thanks for the part #'s

Wayne

> JRPSG911 is the part number for the 911 gear sets...These are the proper
> gears to be using in the 9411 is converting to nylons.
> 
> The regular 9411 gears are fine....you don't need to change them until they
> get sloppy...The metal gears on average will go over a hundred
> flights...where as the nylons I have seen go much longer....as in 200+
> flights without any noticeable wear.
> 
> If the 911 gears are out of stock the 9411 gears may be available  part #
> JRPSG9411
> 
> 
> I have run these servos a bunch..and the 9411's are a great Aileron
> solution.....Don't think just because they are metal gears they need to be
> changed out to nylons....I flew a set last year that was metal setup for
> most of the year...At the same time I was running nylon converted versions
> in another model....After the NATS I switched the metal ones to Nylon
> conversions.....
> 
> Performance is equal...life span of the gears is less with the metal gear
> servos all metal gear servos.
> 
> If you are down and out of flying look for a set of 9411 metal gears.
> 
> Sorry I don't have any gear sets at the moment.....
> 
> Troy Newman
> 
> 
> 
> ----- Original Message -----
> From: "wgalligan" <wgalligan at cnbcom.net>
> To: <discussion at nsrca.org>
> Sent: Wednesday, April 16, 2003 11:27 AM
> Subject: SERVO GEARS
> 
> 
> > Does anyone have any nylon servo gears that will fit in the JR9411 mid
> servo.  The metal gears in mine have gotten sloppy to the point of not
> trusting them.
> >
> > I ordered some several weeks ago but the LHD said they where on back
> order.
> > I need enough for two servos.   Will pay for them or replace them when
> mine come in.
> >
> > Thanks,
> > Wayne
> >
> > BTW WACO contest is 10 days away......
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#