Hinging Techniques

[David Harmon]

I use a plastic dental syringe with the tip cut back to give a 1/16"
outlet and squirt into the slot.
Put a little epoxy on your finger and just wet the surface of the hinge
and it'll never come out.
	Dave

-----Original Message-----
From: discussion-request at nsrca.org [mailto:discussion-request at nsrca.org]
On Behalf Of Nik Middleton
Sent: Monday, September 23, 2002 9:04 AM
To: discussion at nsrca.org
Subject: Hinging Techniques


Hi Guys,,

Need a little advice here.

I normally use the CA type hinges, but I have a 3D plane I'm putting
together that comes with traditional hinges.

My question is this.  I understand that you need to roughen the edges,
put Vaseline on the hinge etc, but how do you ensure you set enough
epoxy in the hinge slot?

rgds



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#



=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#