Patriot C.G.

[Gregory Morris]

Harold,

Thanks for the information, that is where it is set now. I will fine tune it
in the air.

Greg
----- Original Message -----
From: "Harold Collins" <airframe at eatel.net>
To: <discussion at nsrca.org>
Sent: Wednesday, October 23, 2002 10:39 PM
Subject: Re: Patriot C.G.


> Hi Greg,
>
>   The C/G starting point on the Patriot is, centered on the wing tube,
then
> with flight trim you will usually move aft from there.
>   I use a stand to balance one on. The arms will fit between the fuselage
> and the wings allowing a precise balance. As you start to move the C/G aft
a
> gram scale can be used to weigh the tail providing an accurate account of
> any C/G changes.
>    Harold Collins
>    www.ExecutiveAirframes.com
>
>
>
> ----- Original Message -----
> From: "Gregory Morris" <greg_morris at email.msn.com>
> To: <discussion at nsrca.org>
> Sent: Wednesday, October 23, 2002 6:00 PM
> Subject: Patriot C.G.
>
>
> > I'm setting up a Patriot, and do not have any info on the C.G. Does
anyone
> > know where the factory recommended C.G. is in inches from the leading
edge
> > at the root?
> >
> > Thanks
> >
> > Greg Morris
> >
> >
> > =====================================
> > # To be removed from this list, send a message to
> > # discussion-request at nsrca.org
> > # and put leave discussion on the first line of the body.
> > #
> >
> >
>
>
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>
>


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#