[Pattern] YS reassembly

[Terry Terrenoire]

Thanks Dave, I'll change it tonight and give it another try tomorrow.
Will let you kow how it goes!

Terry T.

On Wed, 2 Oct 2002 16:23:18 -0700 "David Harmon" <k6xyz at attbi.com>
writes:
> Terry...yes you are 180 out. Should be just forward of 12 o'clock at 
> tdc
> with valves closed
>         Dave
> 
> -----Original Message-----
> From: pattern-admin at rcmailinglists.com
> [mailto:pattern-admin at rcmailinglists.com] On Behalf Of Terry 
> Terrenoire
> Sent: Wednesday, October 02, 2002 4:08 PM
> To: discussion at nsrca.org; pattern at rcmailinglists.com
> Subject: [Pattern] YS reassembly
> 
> 
> OK, we got it apart, changed the bearings, and got all the parts 
> back
> together again! But it will not run. It wants to start backward, 
> but
> will not sustain the run. I am sure the 
> problem is in the timing position.
> With the piston at TDC, where should the little alignment dimple be? 
> I
> installed it at the 6:00 position as you look at the 
> cam shaft from the right side of the engine. I suspect I may be 180
> degrees off!  BTW the disassembly broblem was solf=ved when I heated 
> it
> to 275 degrees for 1/2 hour.
> 
> Terry T.
> _______________________________________________
> http://www.rcmailinglists.com/mailman/listinfo/pattern
> 
> 
> =====================================
> # To be removed from this list, send a message to 
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
> 
> 
> 
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#