[Pattern] YS reassembly

[David Harmon]

Terry...yes you are 180 out. Should be just forward of 12 o'clock at tdc
with valves closed
	Dave

-----Original Message-----
From: pattern-admin at rcmailinglists.com
[mailto:pattern-admin at rcmailinglists.com] On Behalf Of Terry Terrenoire
Sent: Wednesday, October 02, 2002 4:08 PM
To: discussion at nsrca.org; pattern at rcmailinglists.com
Subject: [Pattern] YS reassembly


OK, we got it apart, changed the bearings, and got all the parts back
together again! But it will not run. It wants to start backward, but
will not sustain the run. I am sure the 
problem is in the timing position.
With the piston at TDC, where should the little alignment dimple be? I
installed it at the 6:00 position as you look at the 
cam shaft from the right side of the engine. I suspect I may be 180
degrees off!  BTW the disassembly broblem was solf=ved when I heated it
to 275 degrees for 1/2 hour.

Terry T.
_______________________________________________
http://www.rcmailinglists.com/mailman/listinfo/pattern


=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#