YS reassembly

[Terry Terrenoire]

OK, we got it apart, changed the bearings, and got all the parts back
together again!
But it will not run. It wants to start backward, but will not sustain the
run. I am sure the 
problem is in the timing position.
With the piston at TDC, where should the little alignment dimple be? I
installed it at the 6:00 position as you look at the 
cam shaft from the right side of the engine. I suspect I may be 180
degrees off!
 BTW the disassembly broblem was solf=ved when I heated it to 275 degrees
for 1/2 hour.

Terry T.
=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#