Too quiet . . . . weight savings idea.

[Anne & Xavier]

Hi Bob,
Can you not have mixed channel 7 to channel 6 with a simple mix?
Is there any standard mix that would not have work thru the second level of
mix.
Xavier


----- Original Message -----
From: "Bob Kane" <getterflash at yahoo.com>
To: "nsrca" <discussion at nsrca.org>
Sent: Thursday, December 05, 2002 4:04 PM
Subject: Too quiet . . . . weight savings idea.


> Either the list is broken or no one has anything to
> say, which I find hard to believe.
>
> I am looking for ways to save weight on my next
> pattern project. I picked up one of the new Hitec
> Electon receivers, dual conversion, 6 channels, .47
> ounces without the case. The only problem is I need
> channel 7 for the 2nd aileron with my Stylus TX. I
> found the channel 7 lead on the decoder chip and was
> able to convert the channel 6 jack to channel 7 by
> cutting the trace and soldering a jumper from the pin
> to a plated-through hole in the trace going to the
> signal pin of channel 6. Well over an ounce saved
> compared to the Stylus 8 channel receiver.
>
>
>
>
> =====
> Bob Kane
> getterflash at yahoo.com
>
> __________________________________________________
> Do you Yahoo!?
> Yahoo! Mail Plus - Powerful. Affordable. Sign up now.
> http://mailplus.yahoo.com
> =====================================
> # To be removed from this list, send a message to
> # discussion-request at nsrca.org
> # and put leave discussion on the first line of the body.
> #
>

=====================================
# To be removed from this list, send a message to 
# discussion-request at nsrca.org
# and put leave discussion on the first line of the body.
#