Dave Brown Vibra Damp T Beam

[ronlock]

Ive used the vibra damp system on beams with an inverted engine,
which worked fine.   I'm not sure what you mean by a bind in
the throttle linkage ?    If you mean stalling the throttle servo near 
the end of it's throw, that needs to be fixed- it causes excessive
current drain, and will contribute to early servo failure.

Later, Ron Lockhart
  ----- Original Message ----- 
  From: Jerry Wilson 
  To: discussion at nsrca.org 
  Sent: Sunday, December 01, 2002 9:33 AM
  Subject: Dave Brown Vibra Damp T Beam


  I have this mount on an ENYA 1.2 4 stroke.  The engine is mounted sideways.  My problem is that the engine sags in the mount so that the alignment is lost after it is run.  This caused a bind in the throttle linkage.  Is this a common problem with this mount?  The screws are very tight.

  I would appreciate any advice  from anyone with experience with this mount.

  thanks,
  Jerry 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.f3a.us/pipermail/nsrca-discussion/attachments/20021201/67ccbdaf/attachment.html