[NSRCA-dist8] Option-160
Tim
tstebbins at gmail.com
Thu Jun 3 19:28:40 AKDT 2010
Congratulations. Is it easier to see at higher altitudes than the
120 ? Also, how did the engine set up run ? Did you already have
the pipe tuned to it or is there some tinkering that has to go on
there as well ?
On Jun 3, 2010, at 7:49 PM, J N Hiller wrote:
> Thought I would let you all know the Option-160 is out of the shop
> and was
> flown today, very conservatively. I'm still working with the motor
> set-up.
> The motor was well used before I got it and it needs bearings.
> That'll be
> the next rainy day project.
> 5 degrees of stab travel felt about normal (full flying stab). It's
> probably
> close. I won't know until I start flying the sequence.
> Bench setup was close, needed 6% left roll trim and 12% up. Next
> will be
> lateral balance evaluation.
> Jim Hiller
>
>
> _______________________________________________
> NSRCA-dist8 mailing list
> NSRCA-dist8 at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-dist8
More information about the NSRCA-dist8
mailing list