[NSRCA-dist8] Option-160
J N Hiller
jnhiller at earthlink.net
Thu Jun 3 18:49:29 AKDT 2010
Thought I would let you all know the Option-160 is out of the shop and was
flown today, very conservatively. I'm still working with the motor set-up.
The motor was well used before I got it and it needs bearings. That'll be
the next rainy day project.
5 degrees of stab travel felt about normal (full flying stab). It's probably
close. I won't know until I start flying the sequence.
Bench setup was close, needed 6% left roll trim and 12% up. Next will be
lateral balance evaluation.
Jim Hiller
More information about the NSRCA-dist8
mailing list