[NSRCA-discussion] Neu bearings- Old style Neu from year 2013

[tocdon at netscape.net]

Boca website stocks smaller bearings in the 1500 and 1100 series motors. No luck finding the part on their website.
I found several other sources.  One is a made in USA brand AST F698HZZ Front.   Diminsions are 8x19x6 with Df of 22mm (flange)

https://www.astbearings.com/catalog.html?page=product&id=F698HZZ
Similarly, rear is a bit smaller at 8x16x4 with Df of 19mm (flange).   They asked me to put in a request for a "quote" or "RFP". 

EXO is what is currently in the rear bearing (EXO F688H) Made in China.
Having said all that, since I started the search, Neu send me a note back and they have some in stock.  Ordered them.
Thanks all who responded back.  
The original bearings in Joseph's 2012, 2013 WC and 2015 WC model are still going strong after 8 years.  I've made this plane my winter practice model.
The V3 is not as quiet or smooth as the V4 but still works wonderfully.
Regards,
Don

-----Original Message-----
From: Jon Lowe <jonlowe at aol.com>
To: tocdon <tocdon at netscape.net>; nsrca-discussion <nsrca-discussion at lists.nsrca.org>
Sent: Fri, Jan 3, 2020 1:12 pm
Subject: Re: [NSRCA-discussion] Neu bearings- Old style Neu from year 2013

Look close at the bearings. Typically the sizes are stamped on them, or they are molded 8nto the seals. Boca is a good place to look.On Friday, January 3, 2020 tim pritchett via NSRCA-discussion <tjpritchett at aol.com; nsrca-discussion at lists.nsrca.org> wrote:
Don,   I'm running the same set up in my Pandora (Neu + V3) If you come up with a source, please share the information...thanks!


-----Original Message-----
From: Don Szczur via NSRCA-discussion <nsrca-discussion at lists.nsrca.org>
To: nsrca-discussion <nsrca-discussion at lists.nsrca.org>
Sent: Wed, Jan 1, 2020 11:09 pm
Subject: [NSRCA-discussion] Neu bearings- Old style Neu from year 2013

I am getting ready to put a Neu motor into an airplane and was checking the bearings.  Pretty sure they are OK but I took apart the motor and figured I might as well change them if some are readily available out there.  If anyone has a source of bearings (front and rear- they look identical) let me know.  Its for a Neu F3A motor used in an earlier Brenner Contra V3 unit (e.g., Joseph's 2013-2015 WC model).
Thanks in advance,


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20200104/cc763963/attachment.html>