[NSRCA-discussion] Neu bearings- Old style Neu from year 2013

Jon Lowe jonlowe at aol.com
Fri Jan 3 09:12:43 AKST 2020


Look close at the bearings. Typically the sizes are stamped on them, or they are molded 8nto the seals. Boca is a good place to look.
On Friday, January 3, 2020 tim pritchett via NSRCA-discussion <tjpritchett at aol.com; nsrca-discussion at lists.nsrca.org> wrote:
Don,   I'm running the same set up in my Pandora (Neu + V3) If you come up with a source, please share the information...thanks!


-----Original Message-----
From: Don Szczur via NSRCA-discussion <nsrca-discussion at lists.nsrca.org>
To: nsrca-discussion <nsrca-discussion at lists.nsrca.org>
Sent: Wed, Jan 1, 2020 11:09 pm
Subject: [NSRCA-discussion] Neu bearings- Old style Neu from year 2013

I am getting ready to put a Neu motor into an airplane and was checking the bearings.  Pretty sure they are OK but I took apart the motor and figured I might as well change them if some are readily available out there.  If anyone has a source of bearings (front and rear- they look identical) let me know.  Its for a Neu F3A motor used in an earlier Brenner Contra V3 unit (e.g., Joseph's 2013-2015 WC model).
Thanks in advance,


_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20200103/ac22dcdb/attachment.html>


More information about the NSRCA-discussion mailing list