[NSRCA-discussion] Electric Prop Adapter

[Matt Griffitt]

Are you looking for a actual prop adapter that clamps to the motor shaft
and has a 6mm threaded stud and nut. Or you looking g for a bushing that
goes on side the prop that's sizes down to 5mm ?

If it's a adapter what are looking for?, one that is a press Colette or a
set screw.I have both.

If it's just a bushing , being that's it's just a mm, I would use some 1/4
wide masking tape and put 2 or 3 rounds around the motor shaft. All the
bushing is doing is holding the prop center while you are tight in the
motor but that is securing the prop.

Matt Griffitt
ADGaero.com
334.380.8228
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20190907/b3941a12/attachment.html>