[NSRCA-discussion] Futaba 18SZ question

[tretas513 at yahoo.com]

It is a challenge to figure out Futaba's programming !
Sent from my Verizon 4G LTE Smartphone
------ Original message------From: David Harmon via NSRCA-discussion Date: Wed, May 22, 2019 10:50 AMTo: 'John Fuqua';'General pattern discussion';Cc: Subject:Re: [NSRCA-discussion] Futaba 18SZ question
Not a secret??????It is in the 18SZ manual???.bottom of page 125.????David Harmon??From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of John Fuqua via NSRCA-discussion
Sent: Tuesday, May 21, 2019 5:43 PM
To: 'General pattern discussion' >
Subject: Re: [NSRCA-discussion] Futaba 18SZ question??And another secret of Futaba Tx???s is revealed not found in the book.??From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of davel322--- via NSRCA-discussion
Sent: Tuesday, May 21, 2019 4:47 PM
To: 'Richard Harn'; 'General pattern discussion'
Subject: Re: [NSRCA-discussion] Futaba 18SZ question??On screen 2 of the Pmix???..???? ???Slave??????? ???Elevator??? ???+???.?? When you add the +, the mix carries to the additional channel being used on the elevator.??Regards,
Dave??From: NSRCA-discussion <nsrca-discussion-bounces at lists.nsrca.org> On Behalf Of Richard Harn via NSRCA-discussion
Sent: Tuesday, May 21, 2019 5:40 PM
To: nsrca-discussion at lists.nsrca.org
Subject: [NSRCA-discussion] Futaba 18SZ question??Have flown this transmitter for 2 years. Wanted to program mix 5 degrees down elevator to low throttle for downlines. After programing the mix only 1 elevator works in the mix. 2 analog jr servos for elevators.Taking out the mix both elevators work normal. What gives???Sent from Mail for Windows 10??
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20190522/899f9e41/attachment.html>