[NSRCA-discussion] Futaba 18SZ question

[David Harmon]

Not a secret……It is in the 18SZ manual….bottom of page 125.

 

 

David Harmon

 

From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of John Fuqua via NSRCA-discussion
Sent: Tuesday, May 21, 2019 5:43 PM
To: 'General pattern discussion' <nsrca-discussion at lists.nsrca.org>
Subject: Re: [NSRCA-discussion] Futaba 18SZ question

 

And another secret of Futaba Tx’s is revealed not found in the book.

 

From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of davel322--- via NSRCA-discussion
Sent: Tuesday, May 21, 2019 4:47 PM
To: 'Richard Harn'; 'General pattern discussion'
Subject: Re: [NSRCA-discussion] Futaba 18SZ question

 

On screen 2 of the Pmix…..   “Slave”   “Elevator” “+”.  When you add the +, the mix carries to the additional channel being used on the elevator.

 

Regards,


Dave

 

From: NSRCA-discussion <nsrca-discussion-bounces at lists.nsrca.org <mailto:nsrca-discussion-bounces at lists.nsrca.org> > On Behalf Of Richard Harn via NSRCA-discussion
Sent: Tuesday, May 21, 2019 5:40 PM
To: nsrca-discussion at lists.nsrca.org <mailto:nsrca-discussion at lists.nsrca.org> 
Subject: [NSRCA-discussion] Futaba 18SZ question

 

Have flown this transmitter for 2 years. Wanted to program mix 5 degrees down elevator to low throttle for downlines. After programing the mix only 1 elevator works in the mix. 2 analog jr servos for elevators.

Taking out the mix both elevators work normal. What gives?

 

Sent from Mail <https://go.microsoft.com/fwlink/?LinkId=550986>  for Windows 10

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20190522/8f71035b/attachment.html>