[NSRCA-discussion] Where Can I Find Connector?

[James Hiller]

http://www.progressiverc.com/
 
 
From: NSRCA-discussion [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ronald Van Putte via NSRCA-discussion
Sent: Tuesday, April 12, 2016 12:08 PM
To: General pattern discussion
Subject: [NSRCA-discussion] Where Can I Find Connector?
 
The Cellpro 10XP and Turnigy 10XC (when they were available) chargers used what I think was a JST PA connector to plug into the charger.  I want to make some new extensions that will plug into the charger and have 5S JST XH balance connectors on the other end.  
 
I previously cut the connector/lead  off the part of the balance board that I didn’t use and soldered the leads to a 5S JST XH balance connector lead.  However, I don’t want to buy more balance connector boards just to get the connector/lead to plug into the charger.
 
Does anyone know where the JST PA connector/lead can be purchased?  Or better yet, does anyone know if I can buy what I need without all the soldering?
 
Ron Van Putte
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20160412/e41c17e7/attachment.html>