[NSRCA-discussion] Transmitter Programming Question

[John Gayer]

Its in the 12Z as well but not needed here. Not sure about the 12FG. 
Although it looks like the 12Z, the software appears to have been 
degraded to support the price differential.
John
On 11/8/2013 7:36 AM, atwooddon at aol.com wrote:
> yes, it does, has had it for about 6-7 years since the 14MZ came out
>
>
>
> -----Original Message-----
> From: Peter Vogel <vogel.peter at gmail.com>
> To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
> Cc: General pattern discussion <nsrca-discussion at lists.nsrca.org>
> Sent: Thu, Nov 7, 2013 11:20 pm
> Subject: Re: [NSRCA-discussion] Transmitter Programming Question
>
> No logical switch function in futaba's?
> ---
> Sent from Mailbox <https://www.dropbox.com/mailbox> for iPhone
>
>
> On Thu, Nov 7, 2013 at 8:21 PM, John Gayer <jgghome at comcast.net 
> <mailto:jgghome at comcast.net>> wrote:
>
>     Don't use a mix.
>     You need to determine first what the necessary channel output
>     value is to turn the glow on.
>     Then set up your plug channel and use throttle stick(J3?) as its
>     input.
>     In AFR, use a "POINT" curve to trigger the output value you need
>     at 15% throttle to turn glow on, you have 9+ points available and
>     I believe you can move their x-coordinate as well.
>     Then, for an ON/OFF switch use a dual rate on the plug channel and
>     the panel switch of your choice. You should then be able to set up
>     a second "POINT" curve when the dual rate is active that has all
>     values set to something that will turn and keep the glow off.
>
>     I don't have a 12FG here to test this but it should work fine.
>     John
>
>     On 11/7/2013 8:11 PM, Ronald Van Putte wrote:
>>     OK.  I think I understand.  Pmix the throttle to the channel the
>>     receiver controlled switch is plugged into and use the throttle
>>     as the Pmix switch.  Yes?
>>
>>     Ron
>>
>>     On Nov 7, 2013, at 8:28 PM, Jas wrote:
>>
>>>     Pmix throttle to glow plug and set the points to turn on where
>>>     you want
>>>
>>>     iJason
>>>     www.jasonshangar.weebly.com <http://www.jasonshangar.weebly.com/>
>>>
>>>     On Nov 7, 2013, at 9:04 PM, Ronald Van Putte
>>>     <vanputter at gmail.com <mailto:vanputter at gmail.com>> wrote:
>>>
>>>>     I think I'll just ignore that.
>>>>
>>>>     Ron
>>>>
>>>>     On Nov 7, 2013, at 8:01 PM, Phil S. wrote:
>>>>
>>>>>     Yes, Ron, switch to JR and it's easy!!!  lol
>>>>>     Phil Spelt, KCRC Emeritus, Past President
>>>>>     AMA 1294 Scientific Leader Member
>>>>>     SPA L-18, Board Member
>>>>>     (865)435-1476v, (865)604-0541c
>>>>>
>>>>>     On 11/7/2013 8:17 PM, Ronald Van Putte wrote:
>>>>>>     I am trying to turn on an onboard glow plug battery on an O.S. .61RF using a receiver controlled switch, so that the glow will be on when the throttle stick position is less than 15% or so and off above that.  I am drawing a blank on how to accomplish it.
>>>>>>
>>>>>>     I've used the throttle stick as a switch before to get dual rate rudder, but this is different.
>>>>>>
>>>>>>     I have a Futaba 12 FG transmitter and will be using a Futaba R617 receiver.
>>>>>>
>>>>>>     *Are there any useful suggestions out there?*
>>>>>>
>>>>>>     Ron Van Putte
>>>>>>
>>>>>>
>>>>>>     _______________________________________________
>>>>>>     NSRCA-discussion mailing list
>>>>>>     NSRCA-discussion at lists.nsrca.org
>>>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>>>>
>>>>>>        
>>>>>     _______________________________________________
>>>>>     NSRCA-discussion mailing list
>>>>>     NSRCA-discussion at lists.nsrca.org
>>>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
>>>>
>>>>     _______________________________________________
>>>>     NSRCA-discussion mailing list
>>>>     NSRCA-discussion at lists.nsrca.org
>>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>     _______________________________________________
>>>     NSRCA-discussion mailing list
>>>     NSRCA-discussion at lists.nsrca.org
>>>     <mailto:NSRCA-discussion at lists.nsrca.org>
>>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 
>>
>>
>>
>>     _______________________________________________
>>     NSRCA-discussion mailing list
>>     NSRCA-discussion at lists.nsrca.org
>>     http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org  <mailto:NSRCA-discussion at lists.nsrca.org>
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20131108/a1423d88/attachment.html>