[NSRCA-discussion] Cutting 3/16 carbon fibre rod

[Phil S.]

I wondered, Ron -- I certainly don't use MINE for cutting carbon fiber 
rods...  ROFL!!!

Phil Spelt, KCRC Emeritus, Past President
AMA 1294 Scientific Leader Member
SPA L-18, Board Member
(865)435-1476v, (865)604-0541c


On 7/12/2013 5:43 PM, ronclark tds.net wrote:
> That's DISK by the way.....................
>
>
> On Fri, Jul 12, 2013 at 4:42 PM, ronclark tds.net <http://tds.net> 
> <ronclark at tds.net <mailto:ronclark at tds.net>> wrote:
>
>     A standard fiber cutoff dick will work too. Cut them in a well
>     ventilated area.
>
>
>     On Fri, Jul 12, 2013 at 4:22 PM, Anthony Cornacchione
>     <acornacchione at hotmail.com <mailto:acornacchione at hotmail.com>> wrote:
>
>         What is the best way to safely cut these rods from Central
>         Hobby?  Thanks in advance for your help.
>
>         No, this is not a question on the judging tests.
>
>         Anthony Cornacchione
>
>         Sent from my iPhone
>         _______________________________________________
>         NSRCA-discussion mailing list
>         NSRCA-discussion at lists.nsrca.org
>         <mailto:NSRCA-discussion at lists.nsrca.org>
>         http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
>
>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20130712/9409b4f9/attachment.html>