[NSRCA-discussion] Cutting 3/16 carbon fibre rod

[Patrick Harris]

Yes, just a regular Dremel cut off wheel is all you need. Cheap and a clean
cut. .


On Fri, Jul 12, 2013 at 2:43 PM, ronclark tds.net <ronclark at tds.net> wrote:

> That's DISK by the way.....................
>
>
> On Fri, Jul 12, 2013 at 4:42 PM, ronclark tds.net <ronclark at tds.net>wrote:
>
>> A standard fiber cutoff dick will work too. Cut them in a well ventilated
>> area.
>>
>>
>> On Fri, Jul 12, 2013 at 4:22 PM, Anthony Cornacchione <
>> acornacchione at hotmail.com> wrote:
>>
>>> What is the best way to safely cut these rods from Central Hobby?
>>>  Thanks in advance for your help.
>>>
>>> No, this is not a question on the judging tests.
>>>
>>> Anthony Cornacchione
>>>
>>> Sent from my iPhone
>>> _______________________________________________
>>> NSRCA-discussion mailing list
>>> NSRCA-discussion at lists.nsrca.org
>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>>>
>>
>>
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20130712/e336c567/attachment.html>