[NSRCA-discussion] Looking for a pattern plane

[Ed Alt]

Not necessarily.  
From: Ronald Van Putte 
Sent: Tuesday, May 08, 2012 6:38 PM
To: General pattern discussion 
Subject: Re: [NSRCA-discussion] Looking for a pattern plane

Hmmmm.  I wonder why I measure different voltages when I switch on the two 2S lipo batteries at different times.  If it had a single regulator, I would think the output voltage would be the same, no matter which battery was chosen. 

Ron

On May 8, 2012, at 5:25 PM, Ed Alt wrote:


  It’s actually a dual output single regulator that can switch between two power sources.  It provides two leads from the same internal source, so only the battery side of things has any redundancy.

  Ed

  From: Ronald Van Putte 
  Sent: Tuesday, May 08, 2012 6:16 PM
  To: General pattern discussion 
  Subject: Re: [NSRCA-discussion] Looking for a pattern plane

  Ron - It is a dual regulator/switch which allows you to hook up two lipo batteries and have them separately regulated to 5.9 volts and use one or both of the outputs.  Look here: 

  http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=16811

  I sell them for under $20.

  Ron



  On May 8, 2012, at 4:42 PM, ronclark tds.net wrote:


    Hey Ron, rusty and old, but I'm going to give it another try. Emory Schroeter told me about a dual regulator for the receiver pack that you are selling, what's the scoop?

    Ron


    On Fri, May 4, 2012 at 5:41 AM, Ronald Van Putte <vanputte at cox.net> wrote:

      Hey Ron:  Buy it and our old fingers can duke it out again.  I look forward to having you on the contest trail again. 

      Ron

      On May 3, 2012, at 11:24 PM, AC Glenn wrote:


        Hey Ron I have a Ca Models Visa for sale ready to fly and would be more than happy to drive it down to your place. 

        Sent from my iPhone

        On May 3, 2012, at 7:39 PM, "ronclark tds.net" <ronclark at tds.net> wrote:


          I'm looking for a used pattern plane. It's been about 10 years since my last contest,   and I want to give these old fingers another chance. I'm looking for a fixed gear 2m design, and plan to do an electric setup. I can convert a methanol burner if necessary.  I live in Nashville,tn., avoiding shipping would be good. Please reply off line to: ronclark at tds.net


          Thanks...Ron
          _______________________________________________
          NSRCA-discussion mailing list
          NSRCA-discussion at lists.nsrca.org
          http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
        _______________________________________________
        NSRCA-discussion mailing list
        NSRCA-discussion at lists.nsrca.org
        http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


      _______________________________________________
      NSRCA-discussion mailing list
      NSRCA-discussion at lists.nsrca.org
      http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


    _______________________________________________
    NSRCA-discussion mailing list
    NSRCA-discussion at lists.nsrca.org
    http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



------------------------------------------------------------------------------
  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion



--------------------------------------------------------------------------------
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20120508/51c528cf/attachment.html>