[NSRCA-discussion] Anyone running a Falcon prop on a Hacker Q60?

[rcmaster199 at aol.com]

For something that is undersized with no appropriate spacer on hand, I've used a length of thin tape to build up to the correct diameter. This works surprisingly well....Try it!

I often use teflon plumber's tape since it is easily conformable, stays put, and is very thin. It is also easy to remove. Remember that once things are tight, the spacer plays no role..........

MattK



-----Original Message-----
From: atwooddon <atwooddon at aol.com>
To: nsrca-discussion <nsrca-discussion at lists.nsrca.org>
Sent: Tue, Jan 10, 2012 11:40 am
Subject: Re: [NSRCA-discussion] Anyone running a Falcon prop on a Hacker Q60?


Redneck lathe?  Been there, done that....  
 
Don



-----Original Message-----
From: trexlesh <trexlesh at msn.com>
To: General pattern discussion <nsrca-discussion at lists.nsrca.org>
Sent: Tue, Jan 10, 2012 8:20 am
Subject: Re: [NSRCA-discussion] Anyone running a Falcon prop on a Hacker Q60?


You could use the Tru-Turn bushings.....just put one on a bolt, chuck it in a drill and dress it with a file to size.

Rex

Sent from my Verizon Wireless Phone


----- Reply message -----
From: "Peter Vogel" <vogel.peter at gmail.com>
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Cc: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Subject: [NSRCA-discussion] Anyone running a Falcon prop on a Hacker Q60?
Date: Tue, Jan 10, 2012 7:16 am




The prop bore is currently 5/16" -- 7.66mm 

Sent from my iPhone4S

On Jan 9, 2012, at 8:49 AM, trexlesh at msn.com <trexlesh at msn.com> wrote:




What do you need for the bushing OD?

Rex

Sent from my Verizon Wireless Phone


----- Reply message -----
From: "Peter Vogel" <vogel.peter at gmail.com>
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Subject: [NSRCA-discussion] Anyone running a Falcon prop on a Hacker Q60?
Date: Sun, Jan 8, 2012 10:43 pm



I've found lots of bushings to adjust an APC prop hub to a smaller shaft, but I haven't found anything that seems like it would work with the Q60's 5mm bolt shaft...  looking for ideas... 


Thanks,
Peter+



-- 

Director, Fixed Wing Flight Training
Santa Clara County Model Aircraft Skypark





_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20120110/cf00cf52/attachment.html>