[NSRCA-discussion] Cleaning up a burr

[Michael Cohen]

While assembling a YS160, I found a lifter would not seat properly.  Right at the edge where the lifter bore meets the crank bore there must be a little burr.  How can I get this cleaned up yet still maintain the tight tolerance in the bore for the lifter?
 
Mike Cohen 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20111031/38799154/attachment.html>