[NSRCA-discussion] Servo centering/tester

[Duane Beck]

I use the one from York Electronics.  It has a repeatable center, unlike the knob/pot units.  I haven't measured the pulse width compared to what comes out of the receiver, though.
http://www.york-electronics.com/

Duane

> Does anyone use a simple servo centering device when installing
> servo's short of hooking up the Tx and Rx?   I know there's a variety
> of servo testers that will center the servo, just looking for the
> best/least expensive setup.  Any suggestions?  I'm always scrambling
> to find a battery/regulator/Rx and then bind it and set it up just to
> center a servo.
> 
> thanks!