[NSRCA-discussion] Servo centering/tester

[Doug Cronkhite]

I don't think that's what he meant.



Sent from my iPhone

On May 17, 2011, at 10:38 AM, Dennis Bodary <d_bodary at yahoo.com> wrote:

> JR MatchMaker Part#JRPA915
> 
> --- On Tue, 5/17/11, Mark Atwood <atwoodm at paragon-inc.com> wrote:
> 
> From: Mark Atwood <atwoodm at paragon-inc.com>
> Subject: [NSRCA-discussion] Servo centering/tester
> To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
> Date: Tuesday, May 17, 2011, 1:31 PM
> 
> Does anyone use a simple servo centering device when installing servo's short of hooking up the Tx and Rx?   I know there's a variety of servo testers that will center the servo, just looking for the best/least expensive setup.  Any suggestions?  I'm always scrambling to find a battery/regulator/Rx and then bind it and set it up just to center a servo.
> 
> thanks!
> 
> 
> Mark Atwood
> Paragon Consulting, Inc.  |  President
> 5885 Landerbrook Drive Suite 130, Cleveland Ohio, 44124 
> Phone: 440.684.3101 x102  |  Fax: 440.684.3102
> mark.atwood at paragon-inc.com  |  www.paragon-inc.com
> 
> 
> 
> 
> 
> -----Inline Attachment Follows-----
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20110517/678587ee/attachment.html>