[NSRCA-discussion] Servo centering/tester

[Dennis Bodary]

JR MatchMaker Part#JRPA915

--- On Tue, 5/17/11, Mark Atwood <atwoodm at paragon-inc.com> wrote:

From: Mark Atwood <atwoodm at paragon-inc.com>
Subject: [NSRCA-discussion] Servo centering/tester
To: "General pattern discussion" <nsrca-discussion at lists.nsrca.org>
Date: Tuesday, May 17, 2011, 1:31 PM

Does anyone use a simple servo centering device when installing servo's short of hooking up the Tx and Rx?   I know there's a variety of servo testers that will center the servo, just looking for the best/least expensive setup.  Any suggestions?  I'm always scrambling to find a battery/regulator/Rx and then bind it and set it up just to center a servo.
thanks!


Mark AtwoodParagon Consulting, Inc.  |  President5885 Landerbrook Drive Suite 130, Cleveland Ohio, 44124 Phone: 440.684.3101 x102  |  Fax: 440.684.3102mark.atwood at paragon-inc.com  |  www.paragon-inc.com






-----Inline Attachment Follows-----

_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20110517/db50380c/attachment.html>