[NSRCA-discussion] Pletty CC HV 85 issue

[Dave]

Betcha you can save that 10 gram ring now with the 2.4 system  :-)

 

Dave

 

  _____  

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Rex
Sent: Thursday, September 30, 2010 11:27 PM
To: NSRCA-discussion
Subject: Re: [NSRCA-discussion] Pletty CC HV 85 issue

 

Dave
 
Mine was definitely a timing issue... I got the screech and everything!
Only happened close to the end of a flight on a long upline, near
the top.  I associated it with heat at first, but that definitely was not
the case.   I would think that any time you get a glitch in commands 
to an esc, you are more than likely to get a timing issue, at least
momentarily.  The ferrite ring solved the problem.... You are correct, it 
was on 72 mhz.   I have always just left the ring on the system. 
 
Rex

 

  _____  

From: DaveL322 at comcast.net
To: nsrca-discussion at lists.nsrca.org
Date: Thu, 30 Sep 2010 22:17:44 -0400
Subject: Re: [NSRCA-discussion] Pletty CC HV 85 issue

Rex / Stuart,

 

Early on, there were quite a few setups that suffered throttle glitches
(intermittent brief power drops), but generally there was not a funny noise
associated with it.  Some of these were cured by various ferrite rings,
chokes, re-orienting RX and wiring, etc..but all of this was with 72 mhz
radio.  I've not seen this type of problem with the 2.4 ghz radios.

 

The problem Stuart is describing sounds different to me - because it has the
funny noise with it.  I'd be more suspect of bad connector, bad solder
joint, fracturing wire, etc.  If we were coming out of the spring into the
summer, I'd suspect increased power from the batteries might be the culprit.

 

Regards,

 

Dave

 

  _____  

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Rex
Sent: Thursday, September 30, 2010 8:49 PM
To: NSRCA-discussion
Subject: Re: [NSRCA-discussion] Pletty CC HV 85 issue

 

Stuart
 
Are you running any sort of choke or ferrite ring on the receiver wire to
the esc?  Several of us had this problem early on...not just
with that combo.  This cured all the woes.  Mine would either start to shut
down or do a herky jerky hesitation thing...and start chirping
like you are talking about.  Like you, I'd throttle down a tad bit then back
up and all would be well.  After I installed the ferrite ring, no 
problems for the last 5 seasons.
Just so you know, I'm using the EVO and Schulze 32-80ka... before that it
was a 30-10 std and 32-55ka....and a 30-10 std with CC hv85.
All did the same thing.   All were cured the same way.  The only combo I had
no problems with was the 30-10 std with the Jeti 77 adv.
 
Rex
 
> Date: Thu, 30 Sep 2010 20:29:29 -0400
> From: schale at optonline.net
> To: nsrca-discussion at lists.nsrca.org
> Subject: [NSRCA-discussion] Pletty CC HV 85 issue
> 
> 
> I am having an intermittent problem with my Plett Evo hooked up to a CC
HV85
> I have run the combination all year without issue. No recent ESC settings
changes.
> On 2 occasions I have heard a "high pitched funny" sound from the motor
with loss of power both times on the vertical line. The first time I landed
right away found no issues and flew the rest of the day without problems
(thought it may have been a sound not from the plane)
> This weekend the same thing happened, lowered the throttle and re-advanced
with normal power and I was able to fly 5 more flights without incident.
> 
> Any ideas?
> 
> Stuart C
> 
> 
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


_______________________________________________ NSRCA-discussion mailing
list NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20101001/9c2545a5/attachment.html>