[NSRCA-discussion] Elevator servo

[Dave]

Yes.

 

  _____  

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Joe Lachowski
Sent: Thursday, October 14, 2010 12:35 PM
To: NSRCA Discussion List
Subject: Re: [NSRCA-discussion] Elevator servo

 

I believe its the 321 gears for the 3421 and the 9011 gears for the 9411. I
know Dave Lockhart can confirm this for sure.
 
> Date: Thu, 14 Oct 2010 15:22:26 +0000
> From: duane.e.beck at comcast.net
> To: nsrca-discussion at lists.nsrca.org
> Subject: Re: [NSRCA-discussion] Elevator servo
> 
> Thanks. Hopefully, it's easier than replacing gears on a micro servo.
> http://www.horizonhobby.com/Products/Default.aspx?ProdID=JRPSG8101
> 
> > Duane,
> > It's not hard to convert an 8411, 3421, or 9411 into the former SA
> > version. In each case, you leave the metal main output gear in place
> > and replace the rest of the metal gears with the appropriate nylon
> > gears. For the 8411, you need a set of gears for an 8101. They're
> > about $4.00 a set. I can't remember the part numbers for the gear
> > sets, but I'm sure someone here will respond shortly with the part
> > numbers you need. Hope this helps.
> > 
> > Verne Koester
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20101014/5c721eda/attachment.html>