[NSRCA-discussion] Elevator servo

[Dave Burton]

You could also use a Futaba 9650, They are about the same size as the 3421,
already have a nylon/plastic gear, and are cheaper.

 

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Duane Beck
Sent: Thursday, October 14, 2010 11:22 AM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Elevator servo

 

Thanks.  Hopefully, it's easier than replacing gears on a micro servo.
http://www.horizonhobby.com/Products/Default.aspx?ProdID=JRPSG8101

> Duane,
> It's not hard to convert an 8411, 3421, or 9411 into the former SA
> version. In each case, you leave the metal main output gear in place
> and replace the rest of the metal gears with the appropriate nylon
> gears. For the 8411, you need a set of gears for an 8101. They're
> about $4.00 a set. I can't remember the part numbers for the gear
> sets, but I'm sure someone here will respond shortly with the part
> numbers you need. Hope this helps.
>
> Verne Koester
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 

  _____  

No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1136 / Virus Database: 422/3196 - Release Date: 10/14/10

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20101014/0f4c1edd/attachment.html>