[NSRCA-discussion] Servicing Servos

Atwood, Mark atwoodm at paragon-inc.com
Mon May 17 09:27:54 AKDT 2010


I assume the number changes for Glow vs Electric?  If so, is that 100-200 typical for Glow or E?  And what should we expect from the other?

-Mark

Mark Atwood
Paragon Consulting, Inc.  |  President
5885 Landerbrook Drive Suite 130, Cleveland Ohio, 44124
Phone: 440.684.3101 x102  |  Fax: 440.684.3102
mark.atwood at paragon-inc.com<mailto:mark.atwood at paragon-inc.com>  |  www.paragon-inc.com<http://www.paragon-inc.com/>

From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of colin chariandy
Sent: Monday, May 17, 2010 1:26 PM
To: General pattern discussion
Subject: Re: [NSRCA-discussion] Servicing Servos

Thanks Tony.

Is the Pot replacement the only work needed to recover the performance and give another 100-200 flights?

Colin

--- On Mon, 5/17/10, Tony <tony at radiosouthrc.com> wrote:

From: Tony <tony at radiosouthrc.com>
Subject: Re: [NSRCA-discussion] Servicing Servos
To: "'General pattern discussion'" <nsrca-discussion at lists.nsrca.org>
Received: Monday, May 17, 2010, 12:44 PM
Colin:
I do a lot of competition pattern servos here at Radio South.  Most of the time, you will be able to get 100-200 flights on servos, however there are some that say they can feel degradation of centering in as few a 30 flights.  Most of the time, replacing a pot will cost you around $20 per servo.


Tony Stillman, President
Radio South, Inc.
139 Altama Connector, Box 322
Brunswick, GA   31525
1-800-962-7802
www.radiosouthrc.com
________________________________
From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of colin chariandy
Sent: Monday, May 17, 2010 12:12 PM
To: NSRCA Mailing List
Subject: [NSRCA-discussion] Servicing Servos

Generally, are people servicing their servos? How often (for glow powered airplanes) and does the service correct chatter about the centre?

Where is a good place to send Futaba Servos and what's the typical cost and turn around time?

Thanks
Colin.



-----Inline Attachment Follows-----
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org<http://ca.mc1126.mail.yahoo.com/mc/compose?to=NSRCA-discussion@lists.nsrca.org>
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100517/1d32ff9f/attachment.html>


More information about the NSRCA-discussion mailing list