[NSRCA-discussion] 8mm standard thread nylon/plastic knurled nuts

[Ron Van Putte]

Go here: http://www.smallparts.com/  and order B000FMYWRU  Nylon 6/6  
Thumb Nut 1/4-20 (Pack of 25) @ $1.09

Yes, a pack of 25 for $1.09.  The shipping was more than the nuts cost!

I have some and they work great.  I glued (CA) 1/4" nylon washers to  
the face of the nuts to increase the contact surface area.

Ron VP

On May 12, 2010, at 11:47 PM, Dave Burton wrote:

> FWIW, the Comp Arf Intrgral metric wing nuts make nice ¼ X 20 wing  
> nuts by just running a ¼ X 20 tap through them.
>
>
>
> From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca- 
> discussion-bounces at lists.nsrca.org] On Behalf Of Richard Strickland
> Sent: Thursday, May 13, 2010 12:35 AM
> To: NSRCA DISCUSSION
> Subject: [NSRCA-discussion] 8mm standard thread nylon/plastic  
> knurled nuts
>
>
>
> I'd like to change out some wing nuts for a round type--where is a  
> good source for light ones.  Are the CompARF units that size and  
> available? Jason?  I'd like to get about (10)
>
> Thanks,
>
> Richard
>
> The New Busy is not the old busy. Search, chat and e-mail from your  
> inbox. Get started.
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.819 / Virus Database: 271.1.1/2869 - Release Date:  
> 05/12/10 14:26:00
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion