[NSRCA-discussion] Perry VP30 Pump

[J N Hiller]

Bob I have a new VP-30 which hasn't been run yet and the adjusting screw is
.140" approximately in the center of the range Vince remembered. This is the
new style pump with a setscrew rather than the older hex head adjusting
screw.
Jim

-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org]On Behalf Of Bob Wilson
Sent: Tuesday, March 30, 2010 3:40 PM
To: General pattern discussion
Subject: [NSRCA-discussion] Perry VP30 Pump

I have a VP30  Perry pump on my O.S. 1.60.  Unfortunately, I've messed
around with the adjustment screw and now have no clue where it was set
originally.  Anyone have an idea how far out from the base the screw is set
from the factory?
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100331/eb364752/attachment.html>