[NSRCA-discussion] Webra 1.60, header, pipe and hyde mount

[Pete Cosky]

Guys,

 

Rick Cilles has this complete setup and wants to sell it. He can be reached
at rcflierrc at hotmail.com

 

He is looking to make it go bye bye and is open to offers...please contact
him if interested.

 

From: nsrca-discussion-bounces at lists.nsrca.org
[mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Michael Cohen
Sent: Sunday, March 07, 2010 4:26 PM
To: NSRCA
Subject: [NSRCA-discussion] Helpful tip - The pin vise!

 

I have been "building" my first pattern airplane, a CARF Integral, and I
have found a good use for a pin vise I thought I would share.  These thin
skin composite aircraft make using a drill overkill, but a dremmel also
tears the daylights out of everything too.  So, since the shafts of the
routing bits, sanding bits, etc.. are small enough to fit in the pin vise, I
have been using that to route out holes, slotting the skins for the control
horns, etc... by hand with much better and cleaner results.  Just thought I
would pass this on.
 
Mike C
D4

  _____  

Hotmail: Free, trusted and rich email service. Get it
<http://clk.atdmt.com/GBL/go/201469228/direct/01/>  now.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100308/384d41f3/attachment.html>