[NSRCA-discussion] Max volts
rcmaster199 at aol.com
rcmaster199 at aol.com
Wed Mar 3 09:58:52 AKST 2010
Dave,
I would argue that the ESC has the sensor built. It isn't a sensor in the sense of a mag pick up such as CDI devices have. It is rather an exact frequency determination to which the motor is driven. It is simpler and hidden. Should we go back on mechanical advance....God no./
I think the CDI electronic advance is similar to today's digital servo. The former advances spark pulsing based on rpm and the latter advances motor output torque based on input load. Whether each violates, not sure. Needs more thought and comparison to the rules. My first take would be to say NO because the magnitude of adjustment is fixed
Matt
----- Original Message -----
From: Dave
To: 'General pattern discussion'
Sent: Wednesday, March 03, 2010 9:47 AM
Subject: Re: [NSRCA-discussion] Max volts
Matt,
One more thought/consideration/question –
Is electronic ignition with variable timing advance illegal? Essentially the RPM is sensed (through a sensor), and as RPM increases, the timing is advanced. The ESCs of today do the same function…they advance timing as RPM increases, but do so without sensor. Should we go back to sensors and mechanical advance devices?
Regards,
Dave
On Mar 2, 2010, at 8:15 AM, rcmaster199 at aol.com wrote:
I had a brief conversation with Dean Pappas on this subject recently. Dean explained that some folks have been advocates of programming the ESC to do some footwork at various stages of battery use. He explained to me just how easy this is to do physically. It seems a few have mentioned something similar in this thread.
I am not that concerned about raising the voltage of the battery as I see this as a somewhat clear violation of the FAI code. I am more concerned about what and how the ESC is "programmed" . I would like for some one with the electronic/software pedigree to explain to me how programming adjustable rates of voltage potential and making these adjustments automatically, does not constitute a programming violation within the rules as they exist today.
When the rules were written, we were clearly dealing with RADIO pre-programmed sequences and the like, no gyros, etc. However I would argue that rate auto adjustments that are definitely possible with the ESC's of today, also qualify as a violation of said rules. Someone should sit down and think this through...I could be convinced otherwise but it needs to be a good argument
MattK
-----Original Message-----
From: Anthony Romano <anthonyr105 at hotmail.com>
To: nsrca-discussion at lists.nsrca.org
Sent: Tue, Mar 2, 2010 8:29 am
Subject: Re: [NSRCA-discussion] Max volts
Keep this line of thinking in mind next time we talk about weight limits! Or any other rules proposal.
Anthony
> From: burtona at atmc.net
> To: nsrca-discussion at lists.nsrca.org
> Date: Mon, 1 Mar 2010 22:45:57 -0500
> Subject: Re: [NSRCA-discussion] Max volts
>
> OK, So I have a question. Is knowingly and purposefully violating the intent
> and letter of the rules to gain a performance advantage called cheating?
> ....... Just asking!
> Dave Burton
>
> -----Original Message-----
> From: nsrca-discussion-bounces at lists.nsrca.org
> [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of James Oddino
> Sent: Monday, March 01, 2010 7:16 PM
> To: General pattern discussion
> Subject: Re: [NSRCA-discussion] Max volts
>
> I have the functional concept that solves the rules problem. Picture a 10S
> pack positive lead wired to the common of a switch with two poles, a piece
> of wire connected from one pole to a pole on a second two pole switch with
> its common connected to the ESC. Between the other two poles we place our
> 11th cell. When the 10S pack is above 37.5 volts the 11th cell is bypassed
> and when it is below, like it will be during vertical maneuvers late in
> flight, the 11th cell is put in series to boost the voltage to up to 41.7
> volts. At no time is the voltage over the spec.
>
> Having said that, I believe the 10S system provides adequate power with the
> right motor at all times of flight even if the voltage drops to 35 volts.
>
> Jim
>
>
> On Mar 1, 2010, at 8:59 AM, Bob Kane wrote:
>
> > Going higher and regulating down would be against the rules, the max volts
> is still limited to 42.56.
> >
> > Bob Kane
> > getterflash at yahoo.com
> >
> >
> > --- On Mon, 3/1/10, krishlan fitzsimmons <homeremodeling2003 at yahoo.com>
> wrote:
> >
> >> From: krishlan fitzsimmons <homeremodeling2003 at yahoo.com>
> >> Subject: Re: [NSRCA-discussion] Max volts
> >> To: chad at f3acanada.org, "General pattern discussion"
> <nsrca-discussion at lists.nsrca.org>
> >> Date: Monday, March 1, 2010, 9:54 AM
> >>
> >> Couldn't we go to a higher voltage and
> >> regulate it back down? A contstant 42.56v would be nice!
> >>
> >> Chris
> >>
> >>
> >>
> >>
> >>
> >>
> >>
> >>
> >>
> >> From: Chad
> >> Northeast <chad at f3acanada.org>
> >> To:
> >> nsrca-discussion at lists.nsrca.org
> >> Sent: Sun,
> >> February 28, 2010 8:48:48 PM
> >> Subject: Re:
> >> [NSRCA-discussion] Max volts
> >>
> >> You would be at about 50% capacity at 3.85 ish volts/cell
> >> (resting open circuit), so unless you up the capacity you
> >> will have a pretty restricted flight time.
> >>
> >> Chad
> >>
> >> On 10-02-28 9:25 PM, Ron Van Putte wrote:
> >>> That stirs a wild thought in my brain. Fully
> >> charged packs don't stay at 4.2 volts per cell very
> >> long. On the other hand, once the initial charge
> >> voltage is burned off by a constant load, the voltage loss
> >> curve "flattens out". What if you put fully
> >> charged 6S and a 5S packs in series and "burn them
> >> down" to 3.869 volts per cell (a total of 42.56
> >> volts for an 11-cell pack) so they were legal for
> >> use. Would the voltage of this depleted 11S pack be
> >> higher than a fully charged 10S pack at the end of a typical
> >> flight? If the end-of-flight voltage might be
> >> significantly higher for the 11S pack vice a 10S pack, it
> >> would be worth investigating, even considering the extra
> >> weight of the additional cell. Come on you electronic
> >> gurus, show me where I'm wrong.
> >>>
> >>> Ron Van Putte
> >>>
> >>> On Feb 28, 2010, at 10:00 PM, James Oddino wrote:
> >>>
> >>>> What comes after ...? Does it specify a load
> >> or any other conditions? Is it measured during the
> >> noise test and have a minimum value?
> >>>>
> >>>> Just stirring the pot, Jim O
> >>>>
> >>>>
> >>>> On Feb 28, 2010, at 5:21 PM, John Fuqua wrote:
> >>>>
> >>>>> No its not (assuming we are talking RC
> >> Aerobatics). Try page RCA-2 para 4.1
> >>>>> which
> >> states "Electrically-powered model aircraft are
> >> limited to a maximum
> >>>>> of 42.56 volts.."
> >>>>>
> >>>>> -----Original Message-----
> >>>>> From: nsrca-discussion-bounces at lists.nsrca.org
> >>>>> [mailto:nsrca-discussion-bounces at lists.nsrca.org]
> >> On Behalf Of Ron Van Putte
> >>>>> Sent: Sunday, February 28, 2010 7:07 PM
> >>>>> To: General pattern discussion
> >>>>> Subject: Re: [NSRCA-discussion] Max volts
> >>>>>
> >>>>> It's in the general rules, not in the R/C
> >> section.
> >>>>>
> >>>>>
> >>>>> On Feb 28, 2010, at 6:50 PM, Jim Quinn wrote:
> >>>>>
> >>>>>> Where can I find the rule
> >> for max volts?
> >>>>>>
> >>>>>>
> >> _______________________________________________
> >>>>>> NSRCA-discussion mailing list
> >>>>>> NSRCA-discussion at lists.nsrca.org
> >>>>>>
> >> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>>>>
> >>>>>
> >> _______________________________________________
> >>>>> NSRCA-discussion mailing list
> >>>>> NSRCA-discussion at lists.nsrca.org
> >>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>>>>
> >>>>>
> >> _______________________________________________
> >>>>> NSRCA-discussion mailing
> >> list
> >>>>> NSRCA-discussion at lists.nsrca.org
> >>>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>>>
> >>>> _______________________________________________
> >>>> NSRCA-discussion mailing list
> >>>> NSRCA-discussion at lists.nsrca.org
> >>>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>>
> >>> _______________________________________________
> >>> NSRCA-discussion mailing list
> >>> NSRCA-discussion at lists.nsrca.org
> >>> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>>
> >> _______________________________________________
> >> NSRCA-discussion mailing list
> >> NSRCA-discussion at lists.nsrca.org
> >> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >>
> >>
> >>
> >>
> >> -----Inline Attachment Follows-----
> >>
> >> _______________________________________________
> >> NSRCA-discussion mailing list
> >> NSRCA-discussion at lists.nsrca.org
> >> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> >
> >
> >
> > _______________________________________________
> > NSRCA-discussion mailing list
> > NSRCA-discussion at lists.nsrca.org
> > http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.733 / Virus Database: 271.1.1/2715 - Release Date: 03/01/10
> 14:34:00
>
> _______________________________________________
> NSRCA-discussion mailing list
> NSRCA-discussion at lists.nsrca.org
> http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
Hotmail: Trusted email with Microsoft’s powerful SPAM protection. Sign up now. =
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
Hotmail: Trusted email with powerful SPAM protection. Sign up now.
__________ Information from ESET Smart Security, version of virus signature database 4910 (20100302) __________
The message was checked by ESET Smart Security.
http://www.eset.com
Your E-mail and More On-the-Go. Get Windows Live Hotmail Free. Sign up now.
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________
SRCA-discussion mailing list
SRCA-discussion at lists.nsrca.org
ttp://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100303/70e2f3de/attachment.html>
More information about the NSRCA-discussion
mailing list