[NSRCA-discussion] Need Dremel Part

[Atwood, Mark]

Better screws on the coffin lid??  

Seriously though, as one who still has my Dremel from 1973 (I know, you were already retired then right??) I finally broke down and bought a new one and have been wondering why I waited so long.  The newer cordless lithium powered units rock.  Take the plunge...   

Mark Atwood
Paragon Consulting, Inc.  |  President
5885 Landerbrook Drive Suite 130, Cleveland Ohio, 44124 
Phone: 440.684.3101 x102  |  Fax: 440.684.3102
mark.atwood at paragon-inc.com  |  www.paragon-inc.com


-----Original Message-----
From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Ron Van Putte
Sent: Tuesday, July 06, 2010 2:58 PM
To: General pattern discussion
Subject: [NSRCA-discussion] Need Dremel Part

I have an old Dremel Freewheeler Model 850 that has a flexible  
coupler between the motor and the output shaft.  This coupler is  
splined on the inside and the splines finally wore out after 20+  
years for no reason at all.  It's on its third or fourth battery  
pack, but still worked fine before the coupler gave out. I've tried  
searching sources for Dremel parts but can't find what I need.  I  
would just buy a new one, but I am stubborn and the son of a Scottish  
mother, who would rise up out of her grave if I did.

Any ideas?

Ron Van Putte 
_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion