[NSRCA-discussion] Perry VP30 Question

[Richard Strickland]

We wore a Supra-Fly 60 out with one mounted on the firewall. It owed us nuthin'.

RS
 


Date: Tue, 16 Feb 2010 06:00:56 -0800
From: humptybump at sbcglobal.net
To: nsrca-discussion at lists.nsrca.org
Subject: Re: [NSRCA-discussion] Perry VP30 Question





The small vent hole is the atmoshpheric pressure reference that balances the regulator in the pump.  The Perry pump is primarily marketed for surface use and the instructions are written with that in mind.  If the vent faces down in a surface application it is less likely to fill with dirt and cause the regualator in the pump to malfunction.  In an aircraft application, you still want the vent to remian free of obstruction at all times, but it is unlikely to stop up with dirt, so orientation is not as important.
 
IMO - Distance from the engine is not critical in a pumped setup.  In a regulator arrangement like Kline, it is critical since the carb draws fuel from the regulator, but not in the pumped setup.  That being said, mine have generally been placed close to the engine.  I did have one setup with the pump behind the firewall.  It had 6 inches or so of fuel line between the pump and carb and operated just like any other setup I used.  Some people use/experiment with a bypass arrangement wihich allows the excess pumped fuel to return the tank and the bypass tee for this needs to be very close to the carb.  We never had much luck with this setup though.  It worked, but was a hassle and did not seem to offer any advantage over the straight pumped arrangement.
 
Richard 





From: Jon Lowe <jonlowe at aol.com>
To: nsrca-discussion at lists.nsrca.org
Sent: Tue, February 16, 2010 7:09:03 AM
Subject: Re: [NSRCA-discussion] Perry VP30 Question


I've mounted them in all kinds of ways and never had a problem.  After all, your plane will be in all kinds of attitudes when it is flying!



Jon Lowe




-----Original Message-----
From: Pascoe,Tim [Burlington] <Tim.Pascoe at ec.gc.ca>
To: nsrca-discussion at lists.nsrca.org
Sent: Mon, Feb 15, 2010 9:53 pm
Subject: [NSRCA-discussion] Perry VP30 Question




I'm putting together a practice plane with an OS1.60, including a Perry VP30 

pump. I've never used a Perry pump before, and am wondering about the mounting 

instructions. It says to ensure that the inflow/outflow nipples are mounted 

horizontally, with the bleed hole down. However, I'm finding it tough to get a 

place near the engine where I can mount it this way.



1) Does it have to be close to the engine (can I mount it inside the fuse behind 

the firewall by 4-5 inches)?

2) Can I mount it with the inflow/outflow vertical, and closer to the engine?



Thanks,



Tim 

_______________________________________________

NSRCA-discussion mailing list

NSRCA-discussion at lists.nsrca.org

http://lists.nsrca.org/mailman/listinfo/nsrca-discussion

 		 	   		  
_________________________________________________________________
Hotmail: Powerful Free email with security by Microsoft.
http://clk.atdmt.com/GBL/go/201469230/direct/01/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20100216/62b322b4/attachment.html>