[NSRCA-discussion] Futaba servo help

[Joe Lachowski]

The same goes for the 3421's
 


From: wcgalligan at att.net
To: nsrca-discussion at lists.nsrca.org
Date: Tue, 28 Dec 2010 15:32:59 -0600
Subject: Re: [NSRCA-discussion] Futaba servo help







A side note to the 9411's.  You can center them mechanically through the output arm.  Takes a very small flat screwdriver.  It made setting up my bi-plane with 4 servos very easy.
 
Wayne Galligan

----- Original Message ----- 
From: Dave 
To: 'General pattern discussion' 
Sent: Monday, December 27, 2010 6:26 PM
Subject: Re: [NSRCA-discussion] Futaba servo help



Dave,
 
I’m guessing you probably know, but it is pretty easy to convert the 9411 to sa with a 911 gearset:
http://www.horizonhobby.com/Products/Default.aspx?ProdID=JRPSG911
 
Replace the middle three gears of the 9411 with the 911 nylon gears, and you’ve got a 9411sa.
 
Regards,
 
Dave Lockhart
Team Horizon/JR/Spektrum/ThunderPower
 
 
 




From: nsrca-discussion-bounces at lists.nsrca.org [mailto:nsrca-discussion-bounces at lists.nsrca.org] On Behalf Of Dave Burton
Sent: Monday, December 27, 2010 6:52 PM
To: 'General pattern discussion'
Subject: [NSRCA-discussion] Futaba servo help
 
I need some help from some of you Futaba guys. Which Futaba mid size digital servo is best suited for ailerons on a 2M pattern ship? I’m not familiar with the numbers of Futaba’s servos
I’m looking for something comparable to the nylon gear JR 9411SA which has been discontinued.
Thanks,
Dave Burton



_______________________________________________
NSRCA-discussion mailing list
NSRCA-discussion at lists.nsrca.org
http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
_______________________________________________ NSRCA-discussion mailing list NSRCA-discussion at lists.nsrca.org http://lists.nsrca.org/mailman/listinfo/nsrca-discussion 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20101229/0010503a/attachment.html>