[NSRCA-discussion] MK Tail wheel

Earl Haury ejhaury at comcast.net
Wed May 27 10:35:58 AKDT 2009


Mark 

Been using the DuBro 3/4" wheel on the MK assembly for years. Drill the hub to fit the axle, chamfer the "inside" of the hub hole (allows the wheel to run closer to the strut), CA wheel to hub, use a (drilled out) 2-56 nut soldered to the axle for a retainer. 

Earl
  ----- Original Message ----- 
  From: Atwood, Mark 
  To: General pattern discussion 
  Sent: Wednesday, May 27, 2009 1:28 PM
  Subject: [NSRCA-discussion] MK Tail wheel


  Does MK make (and does anyone sell) a replacement tail wheel for their light plastic tail wheel assembly?  I hate to replace the whole thing just because the wheel came off.  It's a very thin wheel so the small Dubro's don't work.   Suggestions?

   

  -Mark



------------------------------------------------------------------------------


  _______________________________________________
  NSRCA-discussion mailing list
  NSRCA-discussion at lists.nsrca.org
  http://lists.nsrca.org/mailman/listinfo/nsrca-discussion
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.nsrca.org/pipermail/nsrca-discussion/attachments/20090527/0fec75c9/attachment.html>


More information about the NSRCA-discussion mailing list