[NSRCA-discussion] Header coupler

[Pete Cosky]

You could try summit racing or performance automotive wholesale. Those two should have it.

Pete Cosky
Sent from my Windows Mobile device

-----Original Message-----
From: Rex <trexlesh at msn.com>
Sent: Monday, June 01, 2009 7:02 PM
To: NSRCA-discussion <nsrca-discussion at lists.nsrca.org>
Subject: Re: [NSRCA-discussion] Header coupler


George

 

In a totally different project years ago, I had a similar dilemma...  I used a piece of woven stainless

tubing, inside an outer jacket.  The tubing is made to slide over heater hoses, vaccum lines on engines.

I can't tell you right off hand where to get it, but I'd bet some of the better automotive stores would have

it or could get it.   I simply cut a piece a little longer than the hi temp rubber coupler, slid it inside the 

coupler, then slid both layers over the header/muffler fittings.  Seemed 

[The entire original message is not included]